USB PHY General Control Register
| ENOTG_ID_CHG_IRQ | Enable OTG_ID_CHG_IRQ. |
| ENHOSTDISCONDETECT | For host mode, enables high-speed disconnect detector |
| ENIRQHOSTDISCON | Enables interrupt for detection of disconnection to Device when in high-speed host mode |
| HOSTDISCONDETECT_IRQ | Indicates that the device has disconnected in high-speed mode |
| ENDEVPLUGINDETECT | For device mode, enables 200-KOhm pullups for detecting connectivity to the host. |
| DEVPLUGIN_POLARITY | For device mode, if this bit is cleared to 0, then it trips the interrupt if the device is plugged in |
| OTG_ID_CHG_IRQ | OTG ID change interrupt. Indicates the value of ID pin changed. |
| ENOTGIDDETECT | Enables circuit to detect resistance of MiniAB ID pin. |
| RESUMEIRQSTICKY | Set to 1 will make RESUME_IRQ bit a sticky bit until software clear it |
| ENIRQRESUMEDETECT | Enables interrupt for detection of a non-J state on the USB line |
| RESUME_IRQ | Indicates that the host is sending a wake-up after suspend |
| ENIRQDEVPLUGIN | Enables interrupt for the detection of connectivity to the USB line. |
| DEVPLUGIN_IRQ | Indicates that the device is connected |
| DATA_ON_LRADC | Enables the LRADC to monitor USB_DP and USB_DM. This is for use in non-USB modes only. |
| ENUTMILEVEL2 | Enables UTMI+ Level2. This should be enabled if needs to support LS device |
| ENUTMILEVEL3 | Enables UTMI+ Level3 |
| ENIRQWAKEUP | Enables interrupt for the wakeup events. |
| WAKEUP_IRQ | Indicates that there is a wakeup event |
| ENAUTO_PWRON_PLL | Enables the feature to auto-enable the POWER bit of HW_CLKCTRL_PLLxCTRL0 if there is wakeup event if USB is suspended |
| ENAUTOCLR_CLKGATE | Enables the feature to auto-clear the CLKGATE bit if there is wakeup event while USB is suspended |
| ENAUTOCLR_PHY_PWD | Enables the feature to auto-clear the PWD register bits in USBPHYx_PWD if there is wakeup event while USB is suspended |
| ENDPDMCHG_WKUP | Enables the feature to wakeup USB if DP/DM is toggled when USB is suspended |
| ENIDCHG_WKUP | Enables the feature to wakeup USB if ID is toggled when USB is suspended. |
| ENVBUSCHG_WKUP | Enables the feature to wakeup USB if VBUS is toggled when USB is suspended. |
| FSDLL_RST_EN | Enables the feature to reset the FSDLL lock detection logic at the end of each TX packet. |
| RSVD1 | Reserved. |
| OTG_ID_VALUE | Almost same as OTGID_STATUS in USBPHYx_STATUS Register |
| HOST_FORCE_LS_SE0 | Forces the next FS packet that is transmitted to have a EOP with LS timing |
| UTMI_SUSPENDM | Used by the PHY to indicate a powered-down state |
| CLKGATE | Gate UTMI Clocks |
| SFTRST | Writing a 1 to this bit will soft-reset the USBPHYx_PWD, USBPHYx_TX, USBPHYx_RX, and USBPHYx_CTRL registers |